Customer Reviews
Average Customer Review
(4 customer reviews) 24 of 26 people found the following review helpful
Where's the handle?,
August 4, 2003 Gene Riddle (Oakland, ca United States) - See all my reviews
This review is from: Jet JMG-14 Bandsaw Miter Gauge (708716) (Tools & Home Improvement)
Potential users: Click on the "See Larger Picture" link. Notice that (threaded) hole on the flat part at the top? That's where the handle should be, the handle that gives you oomph to push and guide your stock with the miter gauge. Makes the cutting LOTS easier and more accurate with larger pieces!
Jeez, including this handle with the gauge couldn't have cost 'em more than a couple bucks--but they don't. Nor do they give you any way that I could find to locate and order one.
13 of 13 people found the following review helpful
No stops,
February 25, 2005 Carl F. Daniels "carl33594" - See all my reviews
This review is from: Jet JMG-14 Bandsaw Miter Gauge (708716) (Tools & Home Improvement)
This is a sturdy little unit but it does not have stops for 90 degrees, 45 degrees, etc.
Taking into account the other review, I would not recommend this unit to a friend asking advice.
2 of 3 people found the following review helpful
I Expected Better Quality,
November 19, 2010 Bluegrass - See all my reviews
Amazon Verified Purchase(What's this?)
This review is from: Jet JMG-14 Bandsaw Miter Gauge (708716) (Tools & Home Improvement)
I always expect the best from Jet products but I was disappointed with the miter gauge. This miter gauge is poor quality and has no pre-set notches.
