The new Bosch (DC010) digital display is a special high-visibility LCD-gauge and display for accurately and quickly measuring out cuts on the new 4100-series table saws. When installed and calibrated, it magnetically attaches to the saw's robust and accurate SquareLock - Rip Fence to save time and enhance the accuracy of eachand every cut. Designed for maximum trueness, any measurement is accurate to 1/32-inch, while offering readouts in increments of 1/8-, 1/16-, and 1/32-inchand metric within 0.5 mm. The display is manufactured of die cast aluminum to withstand the worst jobsite abuse and climates. Now, carpenters, remodelers, cabinetmakers, and more can look forward to quicker initial set-up prior to cut, infinite repetitive cut capabilities, less material waste and the precision required to accomplish the highest quality work.
Product Details
Bosch DC010 Digital Carriage Display for 4100-series Table Saws
Comment: The packaging was excellent and I received the product on a promise day. I recommend to buy on Amazon, Definitive we are making deals with a professional.
Customer Rating:
Summary: Bosh should have put some more thought into this 2009-06-13
Comment: I have the table extension, and my rear table extension bashes into this when it is docked on the left side of the table. Also, when the sleep mode is activiated, it does not return automatically when this is moved. Which causes you to have to re-zero the unit every time you do this. And if you start to adjust your fence after a cut and forget to wake this up, you got to got back to square one. I thougt I would use this all the time, but since my fence has a magnifer over the tape, it is quicker for me to just relay on that.
Customer Rating:
Summary: Accurate but glitchy 2009-04-12
Comment: I think that this digital readout is real nice and was very easy to install.
The reason I can only give it three stars is that after I blow off the table saw with some compressed air there is a 50% chance that the digital readout will no longer know where it is relative to the blade. This is not too bad but you do have to remove the blade guards and re-zero the digital readout then put the guards back. The most trouble I've had is when the readout was just slightly off, I make the cut not detecting the error, most of the time when it loses reference it is so far out its obvious. I think this may be happening because of the low relative humidity where I live, lately it has been it the 10% range, I'm thinking that it might be an abundance of static electricity that eventually causes the microprocessor to scramble, just a thought. I have to say when this thing is working correctly it is very nice and accurate.
Customer Rating:
Summary: A MUST have for your 4100-09 Table Saw! 2008-12-31
Comment: This is the EXACT same unit that comes with the 4100DG-09 table saw for $100 more. It works flawlessly and the installation takes about 10-minutes.
The directions for installation are pretty clear, but could be improved. Nonetheless, it was a painless install and I saved $100 by ordering the base 4100-09 and the DG separately.
The unit is deadly accurate and can be set to increments as low as 1/32.
As far as I'm concerned, this is a MUST purchase for Bosch 4000 and 4100 owners!
Customer Rating:
Summary: Goes well with Bosch 4100 Table Saw 2008-05-27
Comment: Went together easily and seems to work well. To date, I haven't checked to see if the measurements are accurate.
You are currently viewing
Bosch DC010 Digital Carriage Display for 4100-series Table Saws